Are you ready to take control of your GM LS/LT build, while taking your knowledge to the next level of performance? Holley Terminator X training from The Tuning School is here to help. Learn how to properly install and set up your Terminator X and Max devices, while also learning a safe and repeatable process for tuning.
Supported modifications for this course: heads/cam, bolt ons, and forced induction setups.
Course Topics:
- Software Operation
- Software Setup
- Datalogging Basics
- Critical Parameters Setup
- Tuning Topics (for N/A and Forced Induction combinations)
- Fuel Injector Sizing
- Engine Size
- Idle/Part Throttle Tuning
- Speedometer and Rear Gear Calibration
- Engine Cooling Controls
- Timing Table Updates
- Fuel Table Updates
- Airflow Table Updates
- WOT Tuning
- Drive by Wire Throttle Response
- Working with the Learn Table
- Target A/F Ratio
- Transmission Tuning
Supported Engines:
LS1/LS6, LS2/LS3, LS 24X 4.8/5.3/6.0 Trucks, LS 58X 4.8/5.3/6.0 Trucks, and Gen V LT applications.
Supported Transmissions:
4L60E and 4L80E (LS Specific) and 4L60 and 4L80 (LT Specific)
The Tuning School
